Pitco Table Error Code
-- CONDITION | POWER SW | POWER LED | HEAT DEM | HFB/FAULT | SIDE ON | HEAT DEM
Source: pitco_controller_error_codes.txt
Stop searching through PDFs. Our AI assistant on WhatsApp is trained on official Pitco documentation and can diagnose this fault code and guide you through the repair in minutes.
5-day free trial — no credit card required.
Other Pitco Error Codes
“Heat Failure”. This code is nine (9) flashes. - FOR VAT TEMPERATURES ABOVE SET
nine (9) flashes.
RIGH NOFILTEROPERATIONS DESCRIPTION DIGIT CODE NON HCODES 21 31 32 22 13 23 33 C
" with an enumeration of descriptions and corresponding codes. There are labeled
P/N 60132703", "Jumper for Electric Operation SCB Roll out for Gas Operation J18
TX, SE14T, SE14TR" with the numbers "700329" and "Rev F" alongside.Rev 700329 SE
CONNECTTOP11 SHEET6 IFEQUIPPED CONNECTTOP12, 230VAC/50Hz IFEQUIPPED J11 240VAC/5
T1 ENTRANCE BOX FRAM 160VAPERAPPLIANCEPLUS BASKETLIFTOPTIONIFINSTALLED FROM J11
+ means the module is bad. New vs Old Module (both PN 60152001): - Old version:
the attempt. The flash codes and their meanings are as follows: · 1 flash: Ignit
2.5A TD"), and power supply units are drawn with labels indicating power ratings
" are also visible, marking specific points or switches in the schematic. Throug