Raypak displayed Error Code
and flashing? and set temperature displayed? YES Diagnostic Readouts "Sensor Fai
Source: sr-410__ray-sr-410-iom.pdf
Stop searching through PDFs. Our AI assistant on WhatsApp is trained on official Raypak documentation and can diagnose this fault code and guide you through the repair in minutes.
5-day free trial — no credit card required.
Other Raypak Error Codes
of Code OFF The desired programmed temperature point is lower than 50°F (10°C) L
060708090|100106 Temp Degrees C 4.41015.621.126.732.237.841.1 Resistance (k) 261
C, TR AsN. COORDINATECHANGES BR ②图 ②B 602125 AUX PEALE NOTES: UNLESS OTHERWSE SP
41."Figure 29. Location of Controls NOTE: Do not stand on the top of the unit, o
F2 F3 1 W2 LEGEND Rp3 GROUND FIELDCONNECTIONSTO C POWTRDEFR.OST1 RAYPAKPUMPS-SEE
04 is at the bottom right corner.Figure 10. Vent Cap Configurations 1" (25mm) MI
1 CSA Type WH2 - Modulating Controls C22.2No.1. Where required by the authority
Controls and modulating valve(s) over an output range of 110°F-170°F Safety Devi
CONNECTION OF HEATER 2 TO STAGE 2 CONNECTION ACAUTION: When servicing controls,
for jurisdictions. The WH2 section illustrates Mechanical Modulation Valves with