Perfect Fry GREASE FILTER Error Code
SYSTEM ERROR - PLEASE CHECK GREASE FILTER: the grease filter is not installed properly.
Source: Perfect Fry/pfa__pfc-pfa-series-english-iom.pdf
What does Perfect Fry GREASE FILTER mean?
On a PFA-series fryer this SYSTEM ERROR means the grease filter is not installed properly. The unit beeps twice and displays the alert, de-energizing the heating element while the fans run. The fryer will not heat normally until the grease filter and its tray are correctly seated in the filter chamber and the condition clears.
Symptoms
- LCD shows *** SYSTEM ERROR *** PLEASE CHECK GREASE FILTER
- Fryer beeps twice to signal the error
- Heating element is de-energized while fans continue to run
- Unit does not return to normal operation
Common causes
- Grease filter is not installed properly
- Grease filter does not sit correctly in the grease tray
- Filter and tray are not properly installed in the filter chamber
Ask the AskWhiz AI about Perfect Fry GREASE FILTER
AskWhiz
online
Diagnostic steps
Seat the grease filter in the tray
Check that the grease filter sits in the grease tray with the magnet on the right-hand end.
Install the tray
Make sure the filter and tray are properly installed in the filter chamber along their rails.
Reinspect alignment
Confirm nothing is preventing the tray from seating fully toward the back of the compartment.
Confirm the error clears
When corrected the fryer beeps twice to signal OK and resumes HEATING.
When to call a professional
If the grease filter and tray are confirmed seated correctly but the SYSTEM ERROR does not clear, contact your authorized service representative or Perfect Fry at 802-658-6600. A fault that persists after the filter assembly is verified may point to a detection switch or wiring problem. Do not attempt to bypass the interlock; qualified service personnel should diagnose the underlying cause.
Stop searching through PDFs. Our AI assistant on WhatsApp is trained on official Perfect Fry documentation and can diagnose this fault code and guide you through the repair in minutes.
5 free questions per bot in your browser — no signup.
Other Perfect Fry Error Codes
SYSTEM ERROR - PLEASE CHECK FRONT PANEL: the hinged front panel is not installed or shut properly.
SYSTEM ERROR - PLEASE CHECK FILTER REPLACEMENT: the air filter cartridge is not installed properly.
SYSTEM ERROR - PLEASE CHECK HEATER BOX: the heating element is not installed properly.
SYSTEM ERROR - PLEASE CHECK AIR FLOW/AIR FILTER: there is improper air flow.
SYSTEM ERROR - PLEASE CHECK FIRE EXTINGUISHER: loss of pressure in the fire extinguisher; system needs to be recharged.
SYSTEM ERROR - PLEASE CHECK PRIMARY OVERTEMP: the heating element is not installed properly.
SYSTEM ERROR - PLEASE CHECK SECONDARY OVERTEMP: cooking oil level is too low or oil has overheated.
SYSTEM ERROR - PLEASE CHECK MAIN FAN: the main ventilation fan is not functioning properly.
SYSTEM ERROR - PLEASE CHECK CONTROL FAN: the control fan is not functioning properly.
SYSTEM ERROR - PLEASE CHECK EBOX FAN: the electronics box fan is not functioning properly.
SYSTEM ERROR - PLEASE CHECK DRAWER MOTOR: the drawer motor has been obstructed.
SYSTEM ERROR - PLEASE CHECK BASKET MOTOR: the basket motor has been obstructed.