Bell and Gossett E2 Error Code
as "2.91 (74)". An additional dimension D3 is labeled "0.91 (23)". The bottom se
Source: e-90e__bego-e-90e-iom.pdf
Stop searching through PDFs. Our AI assistant on WhatsApp is trained on official Bell and Gossett documentation and can diagnose this fault code and guide you through the repair in minutes.
5-day free trial — no credit card required.
Other Bell and Gossett Error Codes
Internal communication error code Description Cause Internal communication lost
E03 Motor overload error DC-bus overvoltage error · High motor current |Stop the
Rotor blocked External conditions cause the operation of the pump from generator
E06 EEPROM Data memory error Grid voltage error EEPROMData memory corrupted Volt
Motor winding temperature error [Motor thermal protection trip · the connection
Power module temperature pump for 5 minutes and then If the problem continues, c
Generic hardware error Hardware error temperature Stop the pump for 5 minutes an
LOW error Pressure sensor error Lack of water detection (if P48= Missing pressur
ERR) tank code sensor (not present in |connection cables ACT mode) Check the con
Description Low pressure error Cause Pressure below [(not present in ACT minimum
Loss of phase error One of the three power supply phases is missing (three- phas
E44 Multi-pump protocol error External analogue reference| External analogue pum