ITW Food Equipment Group 10 Error Code
Wash tank pressure level sensor voltage below lower limit
Source: ITW FOOD EQUIPMENT GROUP/00008 EDH-EDL_EUH-EUL Dishwashers Operation and Error Card F48737 (01-23).pdf
What does ITW Food Equipment Group 10 mean?
The wash tank pressure (water level) sensor is reporting a voltage below its allowed lower limit, so the control cannot trust its wash tank level reading. Cycling power to start draining and then refilling the tank lets the pressure level sensors reset, which often clears the fault.
Symptoms
- Error code 10 shown on the display
- Wash tank water level reading appears incorrect
- Machine will not fill or progress through a cycle
- Error persists until the sensor resets
Common causes
- Wash tank pressure level sensor out of calibration or faulty
- Loss of water or pressure at the sensor
- Wiring or connection fault at the pressure sensor
- Control fault reading the sensor voltage
Ask the AskWhiz AI about ITW Food Equipment Group 10
AskWhiz
online
Diagnostic steps
Power off then on
Press the power button off then on to start the draining process.
Drain and refill
Let the machine drain the tank and refill, which should reset the pressure level sensors.
Confirm the sensor reads correctly
Run a cycle and check whether the wash tank level reading and code 10 have cleared.
Call Hobart Service if it persists
If the error continues to display, contact Hobart Service at 1-888-4HOBART.
When to call a professional
Contact Hobart Service if code 10 stays on after draining and refilling to reset the pressure level sensors. A wash tank level sensor reading below range may be faulty, disconnected or affected by a plumbing issue. An authorized Hobart technician should test the sensor and its wiring and replace it correctly so the wash tank level is measured reliably.
Stop searching through PDFs. Our AI assistant on WhatsApp is trained on official ITW Food Equipment Group documentation and can diagnose this fault code and guide you through the repair in minutes.
5 free questions per bot in your browser — no signup.
Other ITW Food Equipment Group Error Codes
Booster temperature above upper limit
Booster temperature below lower limit
Rinse assurance – booster did not meet temperature or water level requirements
Wash tank temperature above upper limit
Wash tank temperature below lower limit
Booster pressure level sensor voltage above upper limit
Booster pressure level sensor voltage below lower limit
Wash tank pressure level sensor voltage above upper limit
Drain overflow limit – wash tank water level exceeded limit
Wash tank fill time exceeded
Drain error – shutdown; machine took too long to drain
Fill error – booster took too long to fill