Unox WS01 Error Code
Static oven power board over heating warning.
Source: Unox/Unox_XACC-0513-EPLM_ServiceManualAll_CommercialKitchen.pdf
What does Unox WS01 mean?
WS01 is a power board over-heating warning on the static oven accessory. The static oven's power board is running too hot. As a warning the accessory continues with reduced function while flagging the overheating electronics, usually a cooling or installation issue.
Symptoms
- WS01 warning referencing the static oven
- Static oven power board running hot
- Warning during extended use
- Warning clears as the board cools
Common causes
- Inadequate cooling of the power board
- High ambient temperature around the accessory
- Cooling airflow issue
- Power board fault
Ask the AskWhiz AI about Unox WS01
AskWhiz
online
Diagnostic steps
Allow cooling
Let the static oven cool and check whether the warning clears.
Check cooling airflow
Verify cooling airflow over the board and adequate clearance around the accessory.
Check the installation
Confirm the accessory is installed per the manual with proper ventilation.
Service the board
If overheating persists with correct cooling, have the power board checked and replaced if faulty.
When to call a professional
WS01 affects the static oven electronics. Diagnosing the cooling and power board requires accessing the accessory and mains-voltage work; have a qualified Unox technician investigate if a cool-down does not resolve it.
Stop searching through PDFs. Our AI assistant on WhatsApp is trained on official Unox documentation and can diagnose this fault code and guide you through the repair in minutes.
5 free questions per bot in your browser — no signup.
Other Unox Error Codes
Motor thermal protection alarm (permanent error) — the fan motor's thermal protection has tripped.
Safety thermostat alarm — the chamber safety thermostat has tripped above its limit.
Temperature probes alarm — a cooking chamber temperature probe is damaged or disconnected.
Communication error with the power board — the control board lost communication with the power board.
Gas alarm — a fault in the gas burner/ignition system (split into multiple AF23 conditions on later software).
Wrong position of Pollo valve.
Trolley is missing.
Tank missing or safety thermostat fault.
Chamber ceiling temperature too high.
Chamber over-temperature condition (Case 1: T > 150 °C / 302 °F; Case 2: T < 150 °C).
Single-point or multi-point core probe completely damaged.
Chamber temperature probe warning.