AskWhiz
AH2Coreco

Coreco AH2

Carel RTN400 controller — HIGH temperature alarm 2

Source: Coreco_rtn400_instruction_sheet_9is24288-1_rel0413_en_termostatos.pdf

Want this fix in your inbox? Full AH2 guide + every Coreco code, printable, free.

What does Coreco AH2 mean?

On the Coreco controller (Carel RTN400), AH2 is hIGH temperature alarm 2: value read by probe 2 exceeds HA2 after time set in tA2; label AH2 recorded in folder ALr; no effect on control.

Symptoms

  • Display/record shows AH2 in the ALr alarm folder
  • Cabinet warmer than intended
  • No direct effect on control (alarm is signalled)

Common causes

  • Door openings / hot load
  • Dirty condenser or restricted airflow
  • Refrigeration fault (low charge, failing compressor/fan)
  • Alarm threshold/delay set too tight

Diagnostic steps

  1. 01

    Confirm the high-temperature condition

    AH2 means the probe exceeded its HA threshold after the alarm delay. Note the temperature.

  2. 02

    Review thresholds and cooling

    Check HA/tA thresholds, doors, loading and a clean condenser.

Keep this fix — get it by email with every Coreco error code

A clean printable version of this Coreco AH2 guide + the full Coreco code pack (49 codes), straight to your inbox. Free.

I am a — required, one click

When to call a professional

If the alarm reflects a genuine refrigeration fault, have a qualified refrigeration technician diagnose the sealed system; this work is reserved for qualified personnel.

Don't want to DIY this? Open a service ticket on AskWhiz and get it handled — pay per ticket, no subscription.

Open a ticket — free account

Other Coreco error codes

E0

Control probe (probe 1) error — signal interrupted, short-circuited or incompatible probe

E1

Evaporator / defrost probe (probe 2) error — signal interrupted, short-circuited or incompatible probe

E2

Condenser / product probe (probe 3) error — signal interrupted, short-circuited or incompatible probe

IA

Immediate or delayed alarm from the multifunction digital input (external alarm)

dOr

Open-door alarm from the door-switch digital input

LO

Low-temperature alarm — measured temperature below set point by more than parameter AL

HI

High-temperature alarm — measured temperature above set point by more than parameter AH

EE

Unit parameter reading (data) error — saved configuration data error

EF

Operating parameter reading (data) error — manual reset

Ed

Defrost ended by timeout — last defrost stopped on maximum duration, not on temperature

dF

Defrost running — status message shown during a defrost cycle (not an alarm)

CHt

Dirty-condenser warning/alarm — pre-alarm (cht) between Ac-AE and Ac, then alarm (CHt) when Ac is exceeded and refrigeration stops (manual reset)

View all Coreco error codes →