AskWhiz
HiPCoreco

Coreco HiP

Carel RTN400 controller — HIGH voltage alarm

Source: Coreco_rtn400_instruction_sheet_9is24288-1_rel0413_en_termostatos.pdf

Want this fix in your inbox? Full HiP guide + every Coreco code, printable, free.

What does Coreco HiP mean?

On the Coreco controller (Carel RTN400), HiP is hIGH voltage alarm: voltage value read by the analog input is higher than the SPH value; display label HiP, alarm icon permanently on; regulation locked depending on SoU value.

Symptoms

  • Display shows HiP
  • Alarm icon permanently on
  • Regulation may lock depending on the SoU setting

Common causes

  • Supply/analog-input voltage outside the SPH/SPL limits
  • Unstable mains supply
  • Wiring or sensor issue on the analog input

Diagnostic steps

  1. 01

    Check the supply voltage

    HiP means the measured voltage is outside the configured SPH/SPL limits. Verify the actual supply against the limits.

Keep this fix — get it by email with every Coreco error code

A clean printable version of this Coreco HiP guide + the full Coreco code pack (49 codes), straight to your inbox. Free.

I am a — required, one click

When to call a professional

Electrical supply diagnosis is reserved for qualified personnel.

Don't want to DIY this? Open a service ticket on AskWhiz and get it handled — pay per ticket, no subscription.

Open a ticket — free account

Other Coreco error codes

E0

Control probe (probe 1) error — signal interrupted, short-circuited or incompatible probe

E1

Evaporator / defrost probe (probe 2) error — signal interrupted, short-circuited or incompatible probe

E2

Condenser / product probe (probe 3) error — signal interrupted, short-circuited or incompatible probe

IA

Immediate or delayed alarm from the multifunction digital input (external alarm)

dOr

Open-door alarm from the door-switch digital input

LO

Low-temperature alarm — measured temperature below set point by more than parameter AL

HI

High-temperature alarm — measured temperature above set point by more than parameter AH

EE

Unit parameter reading (data) error — saved configuration data error

EF

Operating parameter reading (data) error — manual reset

Ed

Defrost ended by timeout — last defrost stopped on maximum duration, not on temperature

dF

Defrost running — status message shown during a defrost cycle (not an alarm)

CHt

Dirty-condenser warning/alarm — pre-alarm (cht) between Ac-AE and Ac, then alarm (CHt) when Ac is exceeded and refrigeration stops (manual reset)

View all Coreco error codes →