AskWhiz
AL 10Jeros

Jeros AL 10

Overheating of rinse water — temperature above 97°C

Source: 8100-mk3-DK-DE-UK_2014.pdf

Want this fix in your inbox? Full AL 10 guide + every Jeros code, printable, free.

What does Jeros AL 10 mean?

AL 10 means the rinse water has overheated — its temperature has exceeded 97 °C. The alarm appears in the operating panel display, and the manuals' remedy pattern for recurring alarms applies: switch the machine off and on again, and call an engineer if the fault comes back.

Symptoms

  • AL 10 shown on the operating panel display
  • Rinse water temperature above 97 °C

Common causes

  • Rinse water overheated beyond the 97 °C limit

Diagnostic steps

  1. 01

    Stop and let the rinse water cool

    The alarm indicates rinse water beyond 97 °C — pause operation until the temperature falls back into range.

  2. 02

    Switch the machine OFF and then ON again

    Power-cycle the machine to reset the alarm, per the manuals' standard remedy.

  3. 03

    If AL 10 reoccurs, call an engineer

    The mk3 manuals instruct calling an engineer when the fault recurs — persistent rinse overheating is a heating-control fault.

Keep this fix — get it by email with every Jeros error code

A clean printable version of this Jeros AL 10 guide + the full Jeros code pack (12 codes), straight to your inbox. Free.

I am a — required, one click

When to call a professional

Call an engineer if AL 10 returns after a power cycle — the manuals' own instruction for recurring faults. Rinse water that keeps exceeding 97 °C indicates the rinse heating is not being controlled correctly, which is service-level work.

Don't want to DIY this? Open a service ticket on AskWhiz and get it handled — pay per ticket, no subscription.

Open a ticket — free account

Other Jeros error codes

AL 01

Temperature sensor in wash tank disconnected or short-circuited

AL 02

Temperature sensor in rinse tank disconnected or short-circuited

AL 03

Thermal cut-out in wash pump 1 tripped — wash pump overloaded

AL 04

Thermal cut-out in wash pump 2 tripped — machine can continue at reduced operation

AL 05

Thermal cut-out in rinse pump triggered — machine can continue at reduced operation

AL 06

Wash frame motor malfunction — disconnected, short-circuited or travel time exceeded

AL 07

Lid contact malfunction — not switching

AL 08

Lid hoist's maximum travel time exceeded

AL 09

Overheating of wash water — temperature above 85°C

AL 11

Filling time for rinse tank exceeded

AL 13

Incorrect phase sequence — reverse L1 and L2 at the main switch

View all Jeros error codes →

AskWhiz Playground

Test your diagnostic skills

Play a real HVAC service call in the AskWhiz Playground — real brands, real fault codes, no signup.

Play a real service call